For you to avoid undertaking constant oven repair, you need to take good care of your oven. The cool thing is that there are plenty of tips on how to go about it:
Take good care of the blower motor
The blower motor is one of the most important parts
of the oven. For you to keep it in top shape, you need to keep it lubricated. If
the blower motor has oil cups, lubricate it with at least five drops of
non-detergent oil.
When lubricating the motors, follow the manufacturer’s manual. As a rule of thumb, avoid over-lubricating the motor as you will cause more problems than were originally there.
Keep it clean
It goes without saying. A dirty oven not only works
harder than it should, it also tends to develop plenty of problems. For you to
prevent this from happening you should keep your oven clean at all times.
During the cleaning, take a look at the insulation. It’s
common for foreign materials to get caught here making the oven work too hard. For
you to get rid of the dirt you should use a vacuum or air jet to keep the
openings clean.
While you are at it, you also should keep an eye on
the blower wheel and extension shaft set screws. Tighten the screws as
necessary. When tightening them, take care that you don’t over tighten them as
you might crush the isolation or resilient washers.
Isolation washers are located behind the mounting
screws and mounting plate. If you find the washers damaged, replace them.
Inspect the heating elements
Telltale signs that you have an issue with your heating elements is a drop in the performance of the oven or the oven takes a long time to heat up. For you to inspect the elements you need to use a digital multimeter.
For safety reasons, always turn off the power to the
control system. After disconnecting the power, disconnect each element from the
circuit and connect the voltmeter.
A high infinity reading means that the element is
burnt out while a low reading means that you have a normal or good element.
You can also inspect the oven by inspecting the
amperage of the elements. This requires you to use a clip-on ammeter to check
the current draw.
Replace the gas
Do you have a gas oven? You should replace the gas when you notice it dropping. If you have been having your oven for a long time, the moving and swapping of the ovens often create a lot of movement and vibrations that cause leaks in the gas line.
You don’t have any other way out other than to
replace the gas line. Buy a new gas line from the company that installed the
oven for you.
Pay attention to where you place the oven
Where you place the oven is crucial as it determines how well it works. As a rule of thumb, don’t place the oven in an area where airflow around the blower is blocked. You should always be cautious of where the specimen or product is placed in the oven.
You should note that by restricting air inlets and
outlets you reduce airflow through the entire oven, leading to premature oven
failure. The oven also tends to function poorly.
Use the correct power
How much power is getting into the oven? You need to think about this. Some people use reduced power, which isn’t good as it leads to poor performance. At the same time, if you operate with a lot of power, you end up damaging the oven.
If you notice the oven is functioning poorly due to reduced power, consider connecting it to a buck-boost transformer.
Avoid unnecessary heat losses
To prevent the oven from losing a lot of heat, avoid
unnecessary heat losses. For example, if your oven has a light, use a port plug
in the light socket when not using the light. The port plug in the light socket
reduces heat loss and at the same time prevents the socket from malfunctioning
from the heat.
It’s common for the port plug to crack or get damaged. In such a case appliance repair Springfield professionals recommend that you replace it.
